ADC 420F Network Card User Manual


 
Chapter 4: Setting Up for Configuration
Megabit Modem 410F and 420F User Manual 27
SETTING UPTHEPC TO ACCESS THE MODEM
WEB PAGES
To configure and manage your Megabit Modem 410F and 420F F using the Web pages, you
must set up your PC for access. You can set up in one of two ways:
when DHCP is disabled (default) for the modem, enter a static IP address for your PC that
is on a subnet that can access the modem LAN port, as described on page 27
when DHCP is enabled for the modem, the PC and other devices on the LAN automatically
obtain an IP address from the modem, as described on page 29
Setting Up a Static IP Address for the PC
When DHCP is disabled on the modem, set the TCP/IP configuration for the PC to
Specify an IP address. Then, enter an IP address for the PC NIC card that is on a subnet that can
access the modem (see Determining IP Addresses for the Subneton page 22).
See the example on page 28 for setting up the PC to obtain an address when using Microsoft
Windows
®
95. If you use an operating system other than Windows 95, refer to the appropriate
operating system user documentation.