Filter
Top Products
Configuring ADSL Service
54 Megabit Modem 410F and 420F User Manual
4 Configure the ADSL downstream and upstream parameters.
5 Click
Submit when you complete all the ADSL configuration settings.
6 After you make changes to the ADSL configuration, effect the configuration completing
the procedures for “Resetting the ADSL Link” on this page.
Resetting the ADSL Link
Enter the Max Data Rate (kbps). The values entered should be in 32 kbps increments.
If a non-32 kbps value is entered, the value is automatically rounded up to the
nearest 32 kbps value. This is the maximum data rate attainable by the modems, and
the data rate at which the modems sync will be equal to or less than this value as per
the
Startup Option parameter.
The downstream
Max Data Rate (kbps) range is 64 kbps to 7552 kbps, in 32 kbps
increments. The default is
7552.
The upstream
Max Data Rate (kbps) range is 64 kbps to 928 kbps,in32kbps
increments. The default is
928.
Enter the Min Data Rate (kbps). This is the minimum data rate available for the
modems, and the data rate at which the modems sync will be equal to or greater than
this value as per the
Startup Option parameter.
The downstream
Min Data Rate (kbps) range is 64 kbps to 7552 kbps,in32kbps
increments. The default is
64.
The upstream
Min Data Rate (kbps) range is 64 kbps to 928 kbps,in32kbps
increments. The default is 64.
Select the Interleave Option (msec). For downstream and upstream, the options are 02,
04, 08,and16 msec. The default is 04.
Higher interleave values provide more noise immunity, but increase the delay
through the system.
Selecting ADSL Menu, Reset Link brings down the ADSL link between the
Megabit Modem 410F and 420F.