Filter
Top Products
Chapter 3. Configuration
3-40 MX2800 STS-1 User Manual 61200659L1-1
Load Default Settings
Select
L
OAD
D
EFAULT
S
ETTINGS
from the
U
TILITIES
menu. The
screen will display
!WARNING! Defaulting configuration will disrupt
traffic on all ports.
Select
C
ONFIRM
to proceed or press
Esc
to abort.
Update FLASH Software
Select
U
PDATE
F
LASH
S
OFTWARE
from the
U
TILITIES
menu to update
software using either XMODEM protocol or Trivial File Transfer
Protocol (TFTP).
Update Via XMODEM
Select
U
PDATE
VIA
XMODEM
from the
U
PDATE
FLASH S
OFTWARE
menu; then select
1-S
TART
to begin the transfer. Once you select
1-S
TART
from this menu, start the XMODEM transfer from your
terminal menu program (the XMODEM utility is available under
most terminal programs). If you wish to cancel a transfer in
progress, press
Ctrl
-
X
three times.
Loading the default settings will disable all STS-1 ports.
The IP Address, Default Gateway, and subnet mask will not be reset
when default settings are loaded.
This function is available only when updating the software through the
CRAFT
port.