Filter
Top Products
Appendix A. Dedicated Maps Configuration
44 NxT1 HSSI/V.35 User Manual 61200771L1-1
N
X
T1 HSSI
O
PTION
M
ODULE
C
ONNECTS
Write Security: 3; Read Security: 5
Enters the dedicated map connections. Press <Enter> to activate the sub-
menus.
T
O
/F
ROM
C
ONFIG
Write Security: 3; Read Security: 5
Specifies the configuration for the To/From connection. The following
selection applies to the NxT1 HSSI Option Module when connected to a
port on a T1 Module. This is the only valid application for the NxT1 HSSI
Option Module.
DS0 S
ELECTION
Defines DS0s for the T1 port. Use this field to define the DS0s for
this connection.
DS0
S
A
VAILABLE
Indicates which DS0s of the T1 are assigned. DS0 assignment is
based on the following items:
D
IGIT
0-9
This DS0 is available. The digit that displays in this field repre-
sents the last digit of the DS0 number.
*
This DS0 has been requested for this connection, but the DS0 is
not yet activated for this port.
!
This DS0 is used by this port in this connection and is currently
activated.
S
This DS0 is used in the switched DIAL
P
LAN.
The NxT1 HSSI/V35 Module supports connects from the module’s four built-in T1 ports as well as
other installed T1/T3 modules. Enabling the built-in ports by setting the T1 E
NABLE
field to
E
NABLED
(see T1 E
NABLE
on page 32) allows only four T1s from other T1/T3 modules to be
mapped to the HSSI interface in addition to the module’s four built-in ports. When the module’s built-
in T1 ports are active, only ports 5-8 will be displayed in the available S
LOT
/PEP field.
For the NxT1 HSSI Module, any entry in the DS0 selection field that is less than 24 DS0s is
disregarded. The NxT1 HSSI Module requires the use of all 24 DS0s on a T1 for proper
operation.