Filter
Top Products
61
These settings can be freely revised by keying in new paths in the edit boxes.
Figure 4.11 Hotkeys setting
4.4.5.6 DIO
There are 8 digital inputs and 8 digital outputs. This DIO page of the System
Configurator can show their status. When the “Start” button is pressed, the 8
DI will try to retrieve external inputs, then those pins having positive inputs will
mark respective radial buttons inside the “Digital Input Status” block, others will
make their radial buttons empty. On the other hand, when users use mouse,
finger or stylus to check some of the 8 check boxes, the level of the related DO
pins will be changed to positive level. The DO pin status will sustain until users
change them again.
Figure 4.12 DIO setting