Filter
Top Products
18
PROTECT C. may only be operated with or connected to a
220 V / 230 V / 240 V mains with protective grounding using a
CE marked mains connection cable with PE conductor that
has been tested in accordance with national standards.
Danger! Risk of burning!
The battery has powerful short circuit
currents. Incorrect connection or isolation faults
can lead to melting of the plug connections,
sparking potential and severe burns!
The unit has a warning signal that sounds when
the battery voltage of PROTECT C. is exhausted
or when the UPS is not working in its normal
mode (chapter 8, page 45).
Observe the following safety instructions to
ensure permanent operational safety of and safe
work with the UPS and the battery modules
(special accessories):
♦ Do not dismantle the UPS!
The UPS does not contain any parts that require regular
maintenance. Bear in mind that the warranty will be
invalidated if the unit is opened!
♦ Do not install the unit in direct sunshine or in close
proximity of heaters!
♦ The unit is designed to be installed inside in heated
rooms. Never install the housing in the vicinity of water or
in an excessively damp environment!
♦ Condensation may occur if the UPS is brought from a
cold environment into the room where it is to be installed.
The UPS must be absolutely dry prior to start-up. As a
result, leave it to acclimatise for at least two hours.
♦ Never connect the mains input to the UPS output, and
vice versa!
♦ Ensure that no fluids or foreign bodies can penetrate the
housing!