Filter
Top Products
Manual
Page 13 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: info@AEGID.de
4.3.8 Using the Power Supply and Data Cable ID 70212
Using the Power Supply and Data Cable, no special assembly work inside of the SAB Cab has
be done by the customer. After making the link to a power supply and to the connector block
of Serial Data Port, the reader is ready to work.
power supply: brown = + 9 ...30 Volt
white = Ground
serial Interface: green = RxD ( reader receives data‘s )
RS 232 yellow = TxD ( reader sends data‘s )
grey = ground
4.4 Power Supply
The device is designed for DC Current with an voltage in the range between 9. to .30V
DC
. The
minimum power of the power supply is 1.2 Watt. There no need to use special cable to supply
the device.
Attention!
The minimum voltage at the at the readers input mustn’t be lower then 9V.