Filter
Top Products
Manual
Page 5 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: info@AEGID.de
1 Introduction
This document will describe the components of the Compact Reader System ARE I2 / RS 232
and the procedure how to do the first set up of the reader.
The main features of the reader are listed below:
• the antenna is placed inside of the housing (base version)
• there are algorithm available to read nearly all 125 kHz-transponders on market
• the serial RS 232-Interface is placed inside of the housing, allowed baud rate are up to
19200 Bit/s
• the allowed supply voltage is 9 to 30V
DC
• low power consumption of reader < 1.2 Watt
• high reliability for reading and writing within an industrial environment.
• compact housing of the reader with multiple ways for mounting.
• the cabling concept of the reader is optimised to service demands.
• the protection class of the housing is IP65
• there is a set of external antennas available to meet special application demands ( X-tended
version)
2 System Overview
In the base version all electronic components of the reader is placed inside of a small plastic
housing.
Figure 2-1: Concept of the Reading System
RS232
(9-Pin SubD)
Transponder
Reader with
Integrated Antenna
ARE I2
24V
DC