Filter
Top Products
User’s Manual
www.aiptek.eu Page 8
EN
Getting Started
Charging the battery
The internal battery of the device may not be fully charged when
you use the projector for the first time. You can charge the battery
in the following two ways:
● Plug the AC power adapter into the DC-IN jack of the device,
and connect the other end to the power source.
● Connect the small end of the supplied USB cable to the USB
port of the device, and the large end to a powered PC. Make
sure the projector is powered off.
Charging Status Charging Time
Power OFF, charging by AC power adapter around 3 hours
Power OFF, charging by USB connection around 8 hours
Power ON and connect AC power adapter no charging
Power ON and connected with USB cable no charging
Reading LED Indicators
During charging, the LED on the device indicates the level of the internal battery:
● Orange - battery charging
● Green - battery full
When using a PC to charge the battery, always turn off the projector. Otherwise, the
charge will stop.
Inserting a Memory Card
Open the cover of the SD Card Slot. Close the cover of the slot.
Hold the SD card by the edges and gently insert it into the slot (as
shown below) until it reached the bottom of the slot.
To remove the memory card, gently push the top edge of the card
inwards and it will pop up slightly, then pull the card out of the slot.
Connect a USB Dongle
Use the USB Host cable and connect the small end with the USB Connector of the
Projector. Connect the USB dongle on the big end of the cable.