Allied Telesis 86251-08 Switch User Manual


 
Patch 86251-08 For Rapier Series Switches 13
Patch 86251-08 for Software Release 2.5.1
C613-10356-00 REV I
An ETH interface was sometimes shown as Up in the output of the SHOW
INTERFACE command when it was actually Down. This issue has been
resolved.
Under some circumstances traffic did not have NAT applied if a standard
subnet NAT rule was added to a public interface. Such rules did not
correctly match incoming traffic when the REMOTEIP parameter in the
ADD FIREWALL POLICY RULE command was not specified, and the
destination IP address was not the interface’s actual IP address. If this
situation occurred, traffic was redirected back out the public interface. This
issue has been resolved.
Software emulation of layer 3 hardware filtering was not operating
correctly. Packets that the switch had no routing information for were
filtered incorrectly. The first packet of a flow that should have been dropped
was not dropped, and a flow that should have been allowed was being
dropped. This issue has been resolved.
ARP requests with invalid source MAC and IP addresses were being
processed, but should have been dropped. This issue has been resolved.
The SET PIM INTERFACE command did not succeed when the
HELLOTIMER parameter was specified. This issue has been resolved.
Incorrect debug information was returned when an ICMPv6 PacketTooBig
message was received. This issue has been resolved.
ISAKMP in aggressive mode did not establish a connection when the peer
client sent 10 or more payloads. This issue has been resolved.
The IPSec configuration was not created correctly when the RADDRESS
and LNAME parameters in the CREATE IPSEC POLICY command were
used together. This issue has been resolved.
The CREATE IPSEC POLICY command failed if the interface specified with
the INTERFACE parameter did not have a global IPv6 interface defined.
This PCR implements a workaround by using the interface’s link-local IPv6
address if no other IPv6 address can be found.
When ISAKMP was used with IPv6, an incorrect IP address was displayed
in the output of the SHOW ISAKMP EXCHANGE command. This issue has
been resolved.
PCR: 03898 Module: ETH Level: 3
PCR: 03902 Module: FIREWALL Level: 3
PCR: 03906 Module: SWITCH Level: 2
PCR: 03921 Module: IP ARP Level: 3
PCR: 03922 Module: PIM Level: 3
PCR: 03925 Module: IPV6 Level: 3
PCR: 03928 Module: IKMP Level: 2
PCR: 03931 Module: IPSEC Level: 3
PCR: 03934 Module: IPSEC Level: 2
PCR: 03936 Module: IKMP Level: 3