Filter
Top Products
Patch 86251-08 For Rapier Series Switches 31
Patch 86251-08 for Software Release 2.5.1
C613-10356-00 REV I
DHCP was offering network and broadcast addresses to clients. This issue
has been resolved.
An error was not returned if the SET FIREWALL POLICY RULE command
was executed with PROTOCOL=1 when ICMP forwarding was turned on.
This issue has been resolved so that an error is now displayed.
In some circumstances the checksum for the TCP header was set to zero.
This issue has been resolved.
The Switch MIB did not show the correct dot1StpPriority value. This issue
has been resolved.
After creating a trunk group, the activity LEDs did not flash unless the
configuration was used at reboot. This issue has been resolved so that the
LEDs flash correctly whenever a trunk group is created.
The source IP address in a PIM Register message was not the DR interface’s
IP address. This issue has been resolved.
A forwarded PIM-DM state Refresh message did not update the metric and
preference values. This issue has been resolved.
IGMP Query messages were not sent after IGMP was disabled and then re-
enabled. This issue has been resolved.
PCR: 03515 Module: DHCP Level: 3
PCR: 03517 Module: FIREWALL Level: 3
PCR: 03523 Module: FIREWALL Level: 2
PCR: 03526 Module: SWI Level: 3
PCR: 03531 Module: SWI Level: 3
PCR: 03468 Module: PIM Level: 3
PCR: 03533 Module: PIM Level: 3
PCR: 03535 Module: IPG Level: 2