Allied Telesis 86251-08 Switch User Manual


 
44 Patch Release Note
Patch 86251-08 for Software Release 2.5.1
C613-10356-00 REV I
When more than two firewall policies were configured, an unexpected
switch restart sometimes occurred. This issue has been resolved.
PPPoE can now be configured on VLAN interfaces in both Client Mode and
Access Concentrator (AC) mode. To configure PPPoE in Client Mode, the
physical-interface parameter VLANn-servicename has been added, where
servicename is 1 to 18 characters in length, and for a PPPoE client is usually
supplied by the ISP providing the service. To specify that any service name
is acceptable, you can use the special service name ANY.
The modified commands using the VLANn-servicename parameter are:
ADD PPP
•CREATE PPP
DELETE PPP
•SET PPP
SHOW PPP
The modified commands and parameters are described at the end of this
patch release note in “PPPoE Client on VLAN Interfaces” on page 73 For all
other unmodified parameters and commands refer to the PPP Chapter in
your software reference manual.
When an Ethernet port received a MAC Control PAUSE frame it did not
stop transmitting packets for a short period of time, as specified in the IEEE
802.3 Ethernet standard. This issue has been resolved.
The state of a port not participating in STP was displayed as disabled, instead
of broken. This issue has been resolved.
When HTTP proxy was configured and HTTP requests were sent in quick
succession, a fatal error could occur. This issue has been resolved.
PCR: 02429 Module: IPG Level: 2
PCR: 03041 Module: PPP Level: 1
PCR: 03050 Module: ETH Level: 3
PCR: 03058 Module: SWI Level: 4
PCR: 03063 Module: HTTP Level: 1