Filter
Top Products
Patch 86251-08 For Rapier Series Switches 3
Patch 86251-08 for Software Release 2.5.1
C613-10356-00 REV I
A fanAndPsRedundantFanTrap message was sent from a Rapier when the
RPS (Redundant Power Supply) was turned on or off, even though Rapiers
do not monitor the redundant fan status. This issue has been resolved.
The time recorded when a user logged in was overwritten when the same
user logged in a second time while the original connection was still active.
This meant the SHOW USER command displayed the same time for both
connections. This issue has been resolved.
Occasionally a fatal error occurred if BGP debug was disabled. Also, BGP
debug messages were sometimes still displayed after BGP debug was
disabled. These issues have been resolved.
A buffer leak occurred when rapid STP was specified with the SET STP
MODE=RAPID command, but STP had not been enabled with the ENABLE
STP command. This issue has been resolved.
When a file was copied, only blocks of 1024 bytes were copied successfully.
The remainder was discarded. This had two possible consequences. Either
a truncated file was created on the destination media, or the device restarted
with a fatal error. This issue has been resolved so that files copy correctly.
This PCR implements RFC 1256 “ICMP Router Discovery Messages”. This
enhancement allows the device to advertise its interface IP addresses to
local hosts. For details, see “ICMP Router Discovery Advertisements” on
page 47.
When a connector was plugged into one physical interface, the RIPng
request packet was erroneously transmitted from all interfaces on the
switch. This issue has been resolved.
The STATIC and INTERFACE options have been removed from the
PROTOCOL parameter in the ADD IP ROUTE FILTER and SET IP ROUTE
FILTER commands. These parameters were redundant because received
static and interface routes are always added to the route table.
Reverse enhanced NAT was not working for ICMP packets. This issue has
been resolved.
Repeated Assert messages were sent after the prune limit expired. This issue
has been resolved. The default dense mode prune hold time has been
changed from 60 seconds to 210 seconds.
PCR: 03684 Module: CORE Level: 4
PCR: 03726 Module: TTY, USER Level: 3
PCR: 03746 Module: BGP Level: 2
PCR: 03781 Module: STP Level: 2
PCR: 03856 Module: FIRE, UTILITY Level: 2
PCR: 03858 Module: IP
PCR: 03861 Module: IPV6 Level: 2
PCR: 03873 Module: IPG Level: 4
PCR: 03893 Module: FW Level: 3
PCR: 03926 Module: PIM Level: 2