Filter
Top Products
AT-GS900/8PS Switch Installation Guide
51
Resetting Blinking PoE Port LED
To reset a blinking PoE port LED, perform the following steps:
1. Turn the switch power off by disconnecting the AC power cord.
2. If the total PoE power from all the powered devices connected to the
switch is greater than 70 W, reduce the total PoE load until it is less
than 70 W.
3. If a powered device connected to a specific port requires more than 30
W, disconnect it from the switch.
4. Turn on the switch by re-connecting the AC power cord.