Filter
Top Products
Chapter 6: Installing the Linux Driver Software
74
Installing the Linux Driver Software
The section describes the following Linux driver installations:
“Building a Driver from a TAR File” on page 74
“Removing the tg3 Driver” on page 74
Note
On some newer Distributions and Kernels, it may be necessary to
remove the tg3 driver before loading the tg3 driver supplied on the
CD. Follow the instructions in the “Removing the tg3 Driver” on
page 74.
Building a Driver
from a TAR File
To build a driver from a TAR file, perform the following procedure.
1. Create a directory and extract the TAR files:
tar xvzf tg3-<version>.tgz
2. Build the driver tg3.o as a loadable module for the running kernel:
cd tg3-
<version>
/src
make
Test the driver by loading it:
insmod tg3.o
3. Install the driver and man page:
make install
4. To configure network protocol and address, refer to the manuals
supplied with your operating system.
Removing the tg3 Driver
Many various Linux distributions may load the native tg3 driver by default
for the Allied Telesis Gigabit Ethernet Network adapters. It may be
necessary to unload the native tg3 driver first, before installing the tg3.o
driver from this installation.
Note
On some Distributions and Kernels, it may be necessary to remove
the native tg3 driver before loading the Allied Telesis tg3.o driver.
Although tg3 is a fully functioning driver, Allied Telesis recommends that