Filter
Top Products
AT-2900 Series Gigabit Ethernet Network Adapters Installation Guide
79
Note
This parameter is ignored and assumed to be 1 if the line_speed
parameter is set to 0.
full_duplex
This parameter is used together with line_speed to select the
speed and duplex mode of the link. Note that this parameter is
ignored if line_speed is 0. Choose from the following selections:
– 0 - half duplex
– 1 - full duplex (default)
rx_flow_control
Enables or disables receiving flow control (pause) frames. This
parameter is used together with auto_flow_control. Choose from
the following selections:
– 0 - pause receive disabled
– 1 - pause receive enabled if auto_flow_control is set to
0, or pause receive advertised if auto_flow_control is
set to 1 (default)
tx_flow_control
Enables or disables transmitting flow control (pause) frames. This
parameter is used together with auto_flow_control. Choose from
the following selections:
– 0 - pause transmit disabled
– 1 - pause transmit enabled if auto_flow_control is set to
0, or pause transmit advertised if auto_flow_control is
set to 1 (default)
auto_flow_control
Enables or disables Auto-Negotiation of flow control. This
parameter is used together with rx_flow_control and
tx_flow_control to determine the advertised flow control capability.
Choose from the following selections:
– 0 - flow control Auto-Negotiation disabled
– 1 - flow control Auto-Negotiation enabled with
capability specified in rx_flow_control and
tx_flow_control (only valid if line_speed is set to 0 or
auto_speed is set to 1) (default)
mtu
Enables jumbo frames up to the specified MTU size. The valid
range for this parameter is 1500 to 9000. The default is 1500 which