Filter
Top Products
AT-S94 Version 3.0.0.45 Software Release Notes
PN 613-001777 Rev A 13 Allied Telesis, Inc.
7. Before rebooting the stand alone switch or stack, you must change the active image,
including each slave switch in the stack. To check the active image for each switch use the
following command.
Show bootvar
8. The resulting display will tell you which image is active on each switch. Depending on your
configuration, you can now issue one of the following commands, substituting x and y from
the Show bootvar command:
For a stand alone switch -
Boot sys image-y
For each switch in a stack -
Boot sys unit x image-y
9. This command will switch the active image for next reboot.
10. Download the latest boot loader file (s94bv10107.rfb) to your switch or stack. You can find
this file in the Latest_Boot_Loader folder that you have downloaded from the Allied Telesis
web site. Use one of the following commands depending on your configuration:
Note
You must substitute the IP address of your local TFTP server.
For a stand alone switch -
Copy tftp://192.168.1.10/s94bv10107.rfb boot
For a stack configuration -
Copy tftp://192.168.1.10/s94bv10107.rfb unit://*/boot
11. Verify that your switches are running the correct boot loader and management software by
using the following command:
show version
12. Assuming your switch is running the correct bootloader, you have the correct password to
extract the ats94-30045.ros software upgrade file and you know that your current bootloader
is compatible with the Version 3.0.0.45 software.
13. Download the Version 3.0.0.45 software via TFTP by using one of the following commands
depending on your configuration:
For a stand alone switch -
Copy tftp://192.168.1.10/ats94-30045.ros image
For a stack configuration -
Copy tftp://192.168.1.10/ats94-30045.ros unit://*/image