Filter
Top Products
AT-S94 Version 3.0.0.45 Software Release Notes
PN 613-001777 Rev A 4 Allied Telesis, Inc.
Note
If you have a stacked configuration, all switches must be running the latest bootloader and
the same software version before you upgrade the software for the stack.
Note
You can download Version 3.0.0.45files from our web site at www.alliedtelesis.com.
Refer to “Where to Find Product Information and Management Software Updates” on
page 6 for instructions on how to navigate to the software updates page for the AT-8000S.
All of the file names referenced below are contained in the zip file that you download.
1. Log into the switch.
2. For a successful software upgrade of your AT-8000S switch, it is mandatory that you first
install the latest boot loader file (s94bv10107.rfb). You can find this file in the
Latest_Boot_Loader folder that you have downloaded from the Allied Telesis web site.
3. Verify that your switches are running the correct boot loader and management software by
using the following command:
show version
4. If your AT-8000S series switch has Version 1.0.0.25 (or earlier) currently installed on it, go to
the “Upgrade Procedure from Version 1.0.0.25” on page 11. and follow the steps to upgrade
to Version 3.0.0.45. If your AT-8000S series switch has Version 1.1.0.32 or later installed on
it, go to the next step to upgrade to Version 3.0.0.45.
5. With information displayed from the “show version” command, copy the boot version number
exactly as shown. Using this number as the password, extract the ats94-30045.ros software
upgrade file from the ats94-30045.zip file.
6. Assuming your switch is running the correct bootloader, you have the correct password to
extract the ats94-30045.ros software upgrade file and you know that your current bootloader
is compatible with the Version 3.0.0.45 software. If this is the case, you can proceed with the
Version 3.0.0.45 software upgrade by following steps 9 - 11. If this is not the case,
7. If your switch is NOT running the correct bootloader version and you can NOT extract the
ats94-30045.ros software upgrade file and you must install the latest boot loader file provided
(s94bv10107.rfb) by using the following commands:
Note
You must substitute the IP address of your local TFTP server.
For a stand alone switch -
Copy tftp://192.168.1.10/s94bv10107.rfb boot
For a stack configuration -
Copy tftp://192.168.1.10/s94bv10107.rfb unit://*/boot