Filter
Top Products
AT-MC601, AT-MC602 Installation and User’s Guide
38
Configuring the Provider Unit
After performing the procedure described in the previous section, ”Starting
a Configuration Session” on page 36, if you are connected to the Provider
unit, the AT- MC60x Configurator menu will appear. The Configurator bar
at the top of the menu indicates whether or not the Provider unit has
established an Ethernet link by displaying [link DOWN] or [link UP] in
brackets.
The AT-MC60x Configurator menu has three screens: Configuration,
VDSL Status, and Ethernet Status. The parameters on these screens are
described below. Use the tabs at the top of the menu to toggle between
these screens. When you have finished viewing or adjusting the parameters
on the menu screens, click the Close button on the bottom right of the menu
to exit from the configuration software.
Configuration The Configuration screen displayed in Figure 26 is shown first by default.
Figure 26 Configuration