Filter
Top Products
Chapter 6: Installing the Transceivers and Cabling the Ports
150
6. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 107. The connector should snap into the port.
Figure 107. Attaching a Fiber Optic Cable to an XFP Transceiver in the
AT-SBx31XZ4 Line Card
7. Repeat this procedure to install additional XFP transceivers.
After installing and cabling the XFP transceivers in the AT-SBx31XZ4 Line
Cards, do one of the following:
To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
After cabling all the ports in the chassis, go to Chapter 7,
“Powering On the Chassis” on page 153.