Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.117
neighbor dont-capability-negotiate (BGP and
BGP4+)
Use this command to disable capability negotiation for BGP and BGP4+.
The capability negotiation is performed by default. This command is used to allow
compatibility with older BGP versions that have no capability parameters used in open
messages between peers.
Use the no variant of this command to enable capability negotiation.
Syntax [BGP/BGP4+] neighbor <neighborid> dont-capability-negotiate
no neighbor <neighborid> dont-capability-negotiate
Mode [BGP/BGP4+]
Router Configuration
Examples [BGP]
Parameter Description
<neighborid>{<ip-address>|<ipv6-addr>|<peer-group>}
<ip-address> Specify the IPv4 address of the BGP neighbor
in dotted decimal, in the format A.B.C.D.
<ipv6-addr> Specify the IPv6 address of the BGP4+
neighbor, entered in hexadecimal in the
format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) (BGP and BGP+) and neighbor
route-map (BGP and BGP4+) commands.
When this parameter is used with this
command, the command applies on all peers in
the specified group.
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
neighbor 10.10.0.34
dont-capability-negotiate
awplus#
configure terminal
awplus(config)#
router bgp 10
awplus(config-router)#
no neighbor 10.10.0.34
dont-capability-negotiate