Filter
Top Products
BGP and BGP4+ Commands
Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D AlliedWare Plus
TM
Operating System - Software Version 5.4.3-2.6 3.159
neighbor route-map (BGP and BGP4+)
Use this command to apply a route map to incoming or outgoing routes for BGP or BGP4+.
Use the no variant of this command to remove a route map from a BGP or BGP4+ route.
Syntax [BGP/BGP4+] neighbor <neighborid> route-map <mapname> {in|out}
no neighbor <neighborid> route-map <mapname> {in|out}
Mode [BGP]
Router Configuration or IPv4 Address Family Configuration for a VRF instance
Mode [BGP4+] IPv6 Address Family Configuration
Usage [BGP/BGP4+] Use the neighbor route-map command to filter updates and modify attributes. A route
map is applied to inbound or outbound updates. Only the routes that pass the route map
are sent or accepted in updates.
Parameter Description
<neighborid> {<ip-address>|ipv6-addr>|<peer-group>}
<ip-address> Specify the address of an IPv4 BGP neighbor, in
dotted decimal notation A.B.C.D.
<ipv6-addr> Specify the address of an IPv6 BGP4+ neighbor,
entered in hexadecimal in the format X:X::X:X.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups, refer
to the neighbor peer-group (add a neighbor)
(BGP and BGP+) command on page 3.144, and
neighbor route-map (BGP and BGP4+)
command on page 3.159. When this parameter
is used with this command, the command
applies on all peers in the specified group.
<mapname> Specifies name of the route-map.
in Specifies that the access list applies to incoming advertisements.
out Specifies that the access list applies to outgoing advertisements.