Filter
Top Products
C613-10508-01-REV B Software Release Note AlliedWare Plus Version 5.4.3-0.1 11
If your existing configurations include commands modified or deprecated in this version
(see the Status column), check whether you need to modify these configurations. For full
command descriptions, modes and examples, see the appropriate Software Reference for
your switch.
Static IPv6
Multicast
Routes
New Y Y Y Y Y Multicast
Introduction
and
Commands
Rather than having to rely on a dynamic
multicast routing protocol such as PIM to set
up L3 multicast entries, you can now create
these entries statically.
VRRPv3 New Y Y Y Y Y VRRP
Introduction
and
Configuration
The VRRPv3 defined in RFC 5798 for IPv4 and
IPv6 combines two or more physical switches
into a logical grouping called a virtual router
(VR). The physical switches then operate
together to provide a single logical gateway
for hosts on the LAN.
Table 3: New and modified features in 5.4.3
Feature/MIB Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description
Table 4: New and modified commands in 5.4.3
Command Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description
address prefix New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command to specify an address
prefix for address assignment with DHCPv6
server pool configuration.
address range New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command to specify an address
range for address assignment with DHCPv6
server pool configuration.
clear counter
ipv6 dhcp-
client
New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command in Privileged Exec mode to
clear DHCPv6 client counters.
clear counter
ipv6 dhcp-
server
New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command in Privileged Exec mode to
clear DHCPv6 server counters.
clear ipv6 dhcp
binding
New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command to clear all dynamic lease
bindings, or lease bindings specified in the
command. The command will only take effect
on dynamically allocated bindings, not
statically configured bindings. This command
clears binding entries on the DHCPv6 server
binding table.
clear ipv6 dhcp
client
New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command in Privileged Exec mode to
restart a DHCPv6 client on an interface.
dns-server New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command to add an IPv6 address for
a Domain Name System (DNS) server to the
DHCPv6 address pool you are configuring.
domain-name New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command to add a domain name to
the DHCPv6 server address pool you are
configuring.
ipv6 address New Y Y Y Y Y DHCP for IPv6
(DHCPv6)
Commands
Use this command in Interface Configuration
mode for a VLAN interface to add an IPv6
address to the IPv6 prefix provided by a
DHCPv6 Prefix Delegation server.