Filter
Top Products
22 Software Release Note AlliedWare Plus Version 5.4.3-0.1 C613-10508-01-REV B
Revision Modifed Y Y Y Y Y Spanning Tree
Commands
Use this command to specify the MST revision
number. Revision number. The range has
been extended to <0-65535>.
spanning-tree
transmit-
holdcount
Modified Y Y Y Y Y Spanning Tree
Commands
Use this command to set the maximum
number of BPDU transmissions that are held
back. The parameter <1-10> was removed
from the no command.
stack fallback-
config
Deleted Y Y Y Y N Stacking
Commands
This command has been replaced by a trigger
generated from the type stack master-
fail trigger command.
stack mixed-
mode
Deleted N Y N N N Stacking
Commands
This command has been deleted in
AlliedWare Plus 5.4.3 release software. Mixed-
mode VCStacking is available on AlliedWare
Plus 5.4.2 release software. AlliedWare 5.4.3
release software is not available for x600
series switches.
platform fdb-
chain-length
New N N N N Y Switching
Commands
This new command should only be used
when directed by Allied Telesis support
personnel. This command allows you to set
the FDB (forwarding Database) hash chain
length to 4,8, or 16. This command will be
saved in the configuration file and will allow
the silicon FDB hash chain length to be set
after reboot.
card enable New N N N N Y System
Configuration
and
Monitoring
Commands
Use this command to enable or disable a
chassis line card or CFC (Control Fabric Card).
Cards can now be taken in or out of service
when trouble shooting or carrying out
network maintenance. The no variant of this
command disables the card.
ecofriendly Ied New Y Y Y Y Y System
Configuration
and
Monitoring
Commands
Use this command to conserve power by
enabling the eco-friendly LED (Light Emitting
Diode) feature which turns off power to the
port LEDs.
ecofriendly Ipi New Y Y Y Y Y System
Configuration
and
Monitoring
Commands
Use this command to conserve power by
enabling the eco-friendly LPI (Low Power
Idle) feature. This feature reduces the power
supplied to the ports by the switch whenever
the ports are idle and are connected to IEEE
802.3az Energy Efficient Ethernet compliant
host devices.
findme New Y N Y Y N System
Configuration
and
Monitoring
Commands
Use this command to physically locate a
specific device.
reset card New N N N N Y System
Configuration
and
Monitoring
Commands
This command performs a hardware reset of a
card. You can use this command to reset an
unresponsive card.
show card
detail
New N N N N Y System
Configuration
and
Monitoring
Commands
Use this command to display detailed
information about current and provisioned
cards in the chassis.
Table 4: New and modified commands in 5.4.3
Command Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description