Filter
Top Products
C613-10508-01-REV B Software Release Note AlliedWare Plus Version 5.4.3-0.1 23
show
ecofriendly
New Y Y Y Y Y System
Configuration
and
Monitoring
Commands
Use this command to display the switch’s eco-
friendly configuration status. Both
ecofriendly led and ecofriendly
lpi configuration status are shown in the
show ecofriendly output.
show tech-
support
Modified Y Y Y Y Y System
Configuration
and
Monitoring
Commands
Use this command to display information
about system and debugging for the switch.
The card parameter was added.
port-vlan-
forwarding-
priority
New Y Y Y Y Y VLAN
commands
Use this command to set the highest priority
protocol to control transitions from blocking
to forwarding traffic. This command
prioritizes switch port forwarding mode
control, when more than one of EPSR, Loop
Protection, and MAC thrashing protection
protocols are used on the switch.
show port-
vlan-
forwarding-
priority
New Y Y Y Y Y VLAN
commands
Use this command to display the highest
priority protocol that controls port-vlan
forwarding or blocking traffic. This command
displays whether EPSR or Loop Protection is
set as the highest priority for determining
whether a port forwards a VLAN, as set by the
port-vlan-forwarding-priority command.
show vlan Modified Y Y Y Y Y VLAN
Commands
Use this command to display information
about a particular VLAN by specifying the
VLAN ID. The auto parameter was added.
accept-mode New Y Y Y Y Y VRRPv3
Commands
Use this command to configure accept
mode for a master virtual router. If the
accept-mode is set to true, then the switch
will reply to ping, telnet, and ssh requests to
the virtual IP address. The switch will reply
even if it does not own the virtual IP address.
router ipv6
vrrp
New Y Y Y Y Y VRRPv3
Commands
Use this command to configure VRRPv3 for
IPv6 and define the interface that will
participate in virtual routing to send and
receive advertisement messages. This
command allows you to enter the Router
Configuration mode.
show running-
config router
ipv6 vrrp
New Y Y Y Y Y VRRPv3
Commands
Use this command to show the running
configuration for VRRPv3 IPv6.
show vrrp ipv6 New Y Y Y Y Y VRRPv3
Commands
Use this command to display information
about all configured VRRPv3 IPv6 sessions for
all interfaces, or all VRRPv3 IPv6 sessions for a
given interface with the optional
<interface> parameter placeholder.
transition-
mode
New Y Y Y Y Y VRRPv3
Commands
Use this command to configure the IPv4
transition mode. Transition mode allows you
to upgrade from VRRPv2 to VRRPv3 and gives
interoperability between VRRPv2 and
VRRPv3.
virtual-ipv6 New Y Y Y Y Y VRRPv3
Commands
Use this command to set the virtual IPv6
address for the VRRPv3 session. This is the
IPv6 address of the virtual router that end
hosts set as their default gateway.
Table 4: New and modified commands in 5.4.3
Command Status
x510
x610
x900
x908
x8112
Software
Reference
Chapter Description