Filter
Top Products
6 Software Release Note AlliedWare Plus Version 5.4.3-0.1 C613-10508-01-REV B
Support for XEM-12Tv2 and XEM-12Sv2 modules
■ XEM-12Tv2 provides 12x 10/100/1000T (RJ-45) ports for copper cabling
■ XEM-12Sv2 provides 12x 1000X SFP ports for fiber cabling
XEM-12Tv2 and XEM-12Sv2 modules support Extended Mode, the SwitchBlade x908
feature that increases the performance of the SwitchBlade x908. Extended Mode takes
advantage of larger table sizes and Link Aggregation Groups. The following table
describes the increases in system limits when you enable Extended Mode:
Extended Mode for SwitchBlade x908 switches is supported on XEM-2XP, XEM-2XT,
XEM-2XS, XEM-12Tv2, and XEM-12Sv2 modules. Extended Mode for SwitchBlade x908
switches is not supported on XEM-1XP, XEM-12T, or XEM-12S modules.
For more information about configuring Extended Mode for SwitchBlade x908 switches,
see the platform silicon-profile command in the Switching Commands chapter of the
AlliedWare Plus Software Reference for SwitchBlade x908 Switches and x900 Series Switches.
For more information on the XEM-12Tv2 and XEM-12Sv2 modules, see the x900 Series
Switch and SwitchBlade x908 Expansion Module Installation Guide and the x900 Series Switch
and SwitchBlade x908 Hardware Reference. These documents are available from our
website at www.alliedtelesis.com/switches.
SwitchBlade x908
Standard Mode
SwitchBlade x908
Extended Mode
MAC entries 16K 64K
Nexthops 2.5K 8K
QoS Traffic Classes 713 4,096
Link Aggregation Groups 31 128
Access Control Lists 1,024 4,096