Altinex MAX Series Switch User Manual


 
MATRIX SWITCHERS
2
PRECAUTIONS/SAFETY WARNINGS 1
Please read this manual carefully before using your
MAX Series Matrix Switcher. Keep this manual
handy for future reference. These safety
instructions are to ensure the long life of your MAX
Series Switcher and to prevent fire and shock
hazard. Please read them carefully and heed all
warnings.
1.1 GENERAL
Unauthorized personnel shall not open the unit
since there are high-voltage components inside.
Qualified Altinex service personnel, or their
authorized representatives must perform all
service.
1.2 INSTALLATION
For best results, place the MAX Series Switcher
on a flat, level surface in a dry area, away from
dust and moisture. To prevent fire or shock, do
not expose this unit to rain or moisture. Do not
place the MAX Switcher in direct sunlight, near
heaters or heat radiating appliances, or near
any liquid. Exposure to direct sunlight, smoke,
or steam can harm internal components.
Handle your MAX Switcher carefully. Dropping
or jarring can damage the internal components.
Do not place heavy objects on top of the MAX
Switcher.
Do not place the MAX Switcher in direct
sunlight, near heaters or heat radiating
appliances, or near any liquid. Exposure to
direct sunlight, smoke or steam can harm
internal components. Do not pull power cord or
any signal cables that are attached to the MAX.
If the MAX is not to be used for an extended
period of time, disconnect the power cord from
the power outlet.
1.3 RACK-MOUNT INSTALLATION
Use only Altinex supplied rack-mount ears for
mounting the MAX Switcher into a rack.
The maximum operating ambient temperature is
45 degrees Centigrade.
When installing the MAX Series Switcher into a
rack, distribute individual units evenly, otherwise
hazardous conditions may be created by an
uneven weight distribution. Allow 1-U of rack
space for every four MAX Switcher modules for
air circulation. This will reduce heat build up and
will prolong the life of the MAX Switcher.
Connect the MAX Series Switcher to a properly
rated power outlet.
Reliable Earthling of the MAX Series Switcher
should be maintained by connecting using the
provided 3-prong power cord only. Furthermore,
make sure that the rack is properly grounded.
1.4 CLEANING
Unplug the MAX Series Switcher’s power cord
before cleaning.
Clean surfaces with a dry cloth. Never use
strong detergents or solvents such as, alcohol
or thinner. Do not use a wet cloth or water to
clean the unit.
1.5 FCC NOTICE
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference that may cause
undesired operation.
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his own expense.
Any changes or modifications to the unit not
expressly approved by Altinex, Inc. could void
the user’s authority to operate the equipment.