SWITCHERS
6
In addition to forward connection, the MX2214RM
can be hooked up in reverse direction. In this
configuration one video source is selectively sent to
each of the video monitors. This capability is
referred to as bi-directional switching. In this
configuration only one display device can be
operational at any given time.
APPLICATION DIAGRAM 5
INSTALLING YOUR SWITCHER 6
Step 1. Make sure that the power input is set to
the proper AC voltage in your country. An
incorrect setting can result in unit damage
not covered by warranty.
Step 2. Connect the power cord to the unit and
plug it into the power outlet.
Step 3. Connect the cables from the video sources
(computers) to the input channels and
connect the output channel to the display
device (i.e. monitor or projector)
Step 4. If control system is used to control the unit,
connect RS-232 port to the control system
RS-232 card. An improper hook up may
result in RS-232 interface damage.
Step 5. Verify that the picture quality on all
displays is good. If you are not receiving a
signal, make sure that the display is
compatible with the resolution of the
computer graphics card.
Contact Closure control requires the use of part #
RC5204CC Cable.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
1-800-258-4623 or 1-714-990-2300 for
international calls