Filter
Top Products
SWITCHERS
400-0099-003 11
3. [#SW n1 n2 n3 n4 n5 n6] – Input Select
This is the main command of the switcher that
contains all the information needed by the
switcher to activate the video and/or audio
sources that are connected to the unit.
# = Unit ID (# from 1-9, default = 0)
n1 = Input Select (# from 0-6)
n2 = Break Away code (0 = ON, 1 = OFF)
0 = Together
1 = Separate
n3 = Video or Audio (only if Break Away = 1)
0 = Video
1 = Audio
n4 = Sync Delay (# from 0 to 4)
n5 = Video Equalizer (Hex # from 0-F)
n6 = Audio Gain (Hex # from 0-F, 0 = Mute)
Example:
Sending the command [1SW61040F] will activate
switcher Unit ID 1 as follows:
1 Unit ID
SW Define switch/select command
6 Select Input 6
1 Do NOT switch audio and video together
0 Switch video only
4 Set sync delay to 4
0 Set video equalization to 0
F Set audio gain to F
The feedback returned will be as follows:
[1OK]
4. [#RF] – Factory Reset
This command will replace all settings stored in
the memory of the switcher module. This is
indicated by the factory default settings. The
reset operation takes about 3 seconds and all
previous settings will be lost.
# = Unit ID (# from 1-9, default is 0)
Example:
Sending the command [1RF] command will reset
the switcher with Unit ID 1 to the factory settings.
The feedback returned will be as follows:
[1OK]
5. [#RO] – Operation Reset
The [#RO] command will reset audio and video to
Input 1, Auto Switch to OFF and Beep OFF to
Beep ON. However, this command will not affect
audio volume, video equalization, auto-rotation,
and sync-delay.
# = Unit ID (# from 1-9, default is 0)
Example:
Sending the [1RO] command resets the switcher
module with Unit ID 1 in the Reset Mode with ID
number eight.
The feedback returned will be as follows:
[1OK]
6. [#An] – Audio Breakaway
This command controls how audio and video
inputs are selected. The [#An] command allows
the user to control audio input and video input
independently or simultaneously.
# = switch number (Default is 0)
n = 1 (ON) Breakaway audio input from video
input and switchers can be
activated independently.
n = 0 (OFF) In this mode, the switchers are
activated simultaneously. For
example, if Video Input 2 is
pressed, Audio Input 2 will be
pressed automatically.
Example:
Sending the [1A1] command will allow the user to
press Audio Input or the Video Input
independently.
The feedback returned will be as follows:
[1OK]