Filter
Top Products
Installation
2-3
Installation Overview
The following outlines the steps of the installation procedure.
1. Select appropriate locations for the outdoor unit, the antenna (if using an
external antenna) and the indoor unit.
2. Mount the outdoor unit. If using an external antenna mount the antenna and
connect it to the outdoor unit.
3. Connect a ground cable from the outdoor unit to an appropriate grounding point.
4. Connect the indoor-to-outdoor cable to the outdoor unit and route it to the
location selected for the indoor unit. Refer to Appendix B for instructions on
preparing the indoor-to-outdoor cable.
5. Mount the indoor unit. Connect the indoor-to-outdoor cable to the indoor
unit’s Radio port.
6. Connect the indoor unit’s Ethernet port to the user’s network using an
Ethernet cable.
7. Configure the unit’s parameters.
8. Align the antenna and verify connectivity with any other units.
NOTE:
The indoor unit should only be connected to the power source after it has been connected to the
outdoor unit.