Filter
Top Products
The DS.11 Configuration Utility
3-3
Unit Configuration Mode
The following sections describe the various screens, controls and parameters
available in Unit Configuration mode.
Control Window
In this section, you can:
♦ Discover the units that are connected to the network.
♦ View the DS.11 units that have been discovered by their IP address.
♦ Select the units you wish to manage.
♦ Locate units behind a router that cannot be detected by the autodiscovery
feature
♦ Assign unit IP addresses based on unit MAC addresses.
♦ Set the SNMP Community string.
NOTE:
If there are many units in the managed network, you can enlarge the list box by clicking the horizontal line
above the list Click again to toggle back the default display state. The list box also displays the location of
each unit, as set in the Station Status window.
Tabs Section
This section consists of several tabs, each containing parameters required for the
management of the selected unit. The different tabs are described in the following
sections. When you switch between the tabs, the unit selection section with the
selected unit address remains displayed.
T
ab Selection
Are
a
Control
and Unit
Selection
Are
a
Selected Tab
Figure
3-1: DS.11 Configuration Utility Main Window (Station Control Tab)