Filter
Top Products
The DS.11 Configuration Utility
3-27
♦ Set Compatibility Mode: Click to set the following parameters, which are
unique to DS.11 version 4.0, to values that will ensure interoperability with
DS.11 units running previous versions as well as with other IEEE 802.11
compliant devices:
Basic rate=2Mbps
Short preamble = Disable (BU)
Scrambling: Disable
NOTE:
To ensure compatibility, verify that a 128-bit WEP Key is not used.
♦ Set High Performance Mode: The units can be configured to deliver high
performance (high throughput) if the RSSI of all links is –80 dBm or better,
provide that all units run SW version 4.0. Upon clicking this button, the
following parameters will be configured to support high performance:
Basic rate=11Mbps
Short Preamble = Enable (only in BU)
Trap Monitor Tab
The Trap Monitor tab enables you to view messages received from the selected unit.
Figure
3-17: Trap Monitor Tab
When an event occurs, a trap is sent to the defined host address (the setting is
made in the SNMP Parameters tab described on page 3-7). This window displays
the recorded traps.
Click Clear List to clear the display area.