Filter
Top Products
MX28B-1200+27V PRODUCT MANUAL Rev 1
12
5 INSTALLATION PROCEDURES
5.1 Preparation
5.1.1 Recommended Tools
• Standard selection of insulated hand tools.
• Proper tools for crimping the selected cable lugs.
5.1.2 Recommended Test Equipment
• Digital Multimeter
5.1.3 Equipment Inspection
Remove equipment from packing material and inspect for shipping damage to verify the safety and
operational suitability for the installation site. [Refer to Section 1.3]
5.1.4 Safety Precautions
***** WARNING *****
The power plant is supplied from a nominal 230V AC, 50/60 Hz source. Keep All AC input
enclosure covers in place when the system is operational or energized.
***** CAUTION *****
Handling or touching the controller boards located inside this unit without being electro
statically discharged (grounded to the frame) may cause extensive damage to the electronics.
Before touching or handling the controller boards, it is recommended that an ESD wrist strap be
utilized.
***** WARNING *****
Hazardous energy levels are present on bare conductors in the +24 and -48V DC distribution
connection areas of the plant. Accidental shorting of distribution conductors can cause arcing
and high currents that can cause serious burns or other physical harm.
It is recommended that:
• Any jewelry, rings or watches be removed while working on this equipment.
• Handles of all wrenches, screwdrivers, cutters and pliers be insulated.
• Shafts of screwdrivers be wrapped in electrical tape or otherwise insulated.