Filter
Top Products
3 990-1060B 12/2005
2: INSTALLATION
UNPACKING
Inspect the UPS upon receipt. APC designed robust packaging for your product. However, accidents
and damage may occur during shipment. Notify the carrier and dealer if there is damage.
The packaging is recyclable; save it for reuse or dispose of it properly.
Check the package contents. The shipping package contains the UPS (with batteries disconnected);
its front bezel (packaged separately); feet (required in tower configuration); and a literature kit con-
taining a software CD, one serial cable, power cord(s), screws for the feet, and product documenta-
tion.
The UPS is shipped with the battery disconnected and the front bezel removed. You
will connect the battery and install the plastic bezel (described later) during the installa-
tion procedure.
POSITIONING THE UPS
Place the UPS where it will be used. The UPS is heavy. It requires two people for installation due to
its weight. To lighten the UPS, you may remove the battery while you position the UPS. See Re-
moving the Battery Pack, below, for instructions. Select a location sturdy enough to handle the
weight.
You must install the UPS in a protected area that is free of excessive dust and has adequate airflow.
Ensure the air vents on the front and rear of the UPS are not blocked. Allow at least one inch of space
on each side.
Do not operate the UPS where the temperature and humidity are outside the specified limits. Refer to
the Specifications at the APC web site (www.apc.com).
Placement
Smar
Smar
Smar