American Power Conversion 480kW 400V Power Supply User Manual


 
External Connection
990-4059
Installation Guide APC Silcon 480kW 400V UPS 23
4.7.5 Troubleshooting
The following table shows the solution to common problems with the operation of the Triple
Chassis
4.7.5.1 If Problems Persist
For problems not covered in the troubleshooting chart or for persistent problems, follow this
procedure:
1) Note the serial number and date of purchase of the APC Silcon Triple Chassis. Contact APC
Customer Support at the phone number or address that is listed in this manual.
2) Be prepared to provide a description of the problem. A technician will help solve the
problem over the phone, if possible, or will give you a return material authorization (RMA)
number.
3) If the APC Silcon Triple Chassis is under warranty, repairs are free of charge. If the
warranty has expired, there will be a nominal charge for repair.
AP9604S[R] APC Silcon Triple Chassis 90
AP9606 Web/SNMP Management Card 110
AP9607 Interface Expander 45
AP9608 Out-of-Band Management Card
(Call-
UPS
II)
35
AP9612 Environmental Monitoring Card (Measure-UPSII) 60
AP9825i Isolated Extension Cable 50
AP9830 Remote Power-Off Device 35
Problem Possible Cause Solution
Status LED is off
The chassis is not
receiving adequate
power.
See Powering the APC Silcon Triple
Chassis, and verify that you are not
exceeding current requirements.
Status LED is flashing
quickly
The chassis has not been
configured.
Configure the Silcon Triple Chassis.
See the APC Silcon Management
Quick Start Guide provided with your
chassis or the Web/SNMP
Management Card Installation Guide
on the CD for more information.
Status LED is flashing
slowly
The chassis is not
communicating with the
UPS.
Verify that the supplied UPS cable is
properly connected to the Triple
Chassis and to a communications
port on the UPS.
Attached management
peripheral cannot identify
UPS model or nominal
output voltage.
The management
peripheral firmware does
not support 3-phase
UPSs.
You may be able to upgrade the
firmware of the management
peripheral. Call APC Customer
Support.