Filter
Top Products
Operation
11
Solecis AVS-SL-PR-0201-0301 Presentation Switcher
Operation
Power On
This button turns the display device on, the button lights to show the current status.
Power Off
This button turns the display device off, the butt on lights to show the current status.
PC1 & PC2
These button allow input selection of the two PC inputs. The button lights to reflect the press.
Video 1, 2 & 3
Same as PC1 & PC2 but for the video inputs.
AUX
Same again but for the auxiliary audio input. This can only be selected in AV & Audio modes.
Mute / Blank
Blanks the video and mutes the audio in AV mode, blank in video mode and mute in audio.
Mode
Toggles between the three modes, AV, Video and Audio.
Volume Up & Down
Used to control the volume of the line level output. This control is a master volume control and thus
affects all of the input volume levels but does not change the differences in attenuation. There fore once
the input with the highest attenuation level reaches minimum volume, the volume cannot be reduced any
more regardless of the current input level. The same applies for increasing the volume.
Mic Mix
When selected, the switched audio is combined with the microphone onto the balanced output. By
holding the mix button for 2-3 seconds, the unit is placed in microphone volume adjust mode. The
volume control lights will flash and at which point the volume buttons will now control the microphone
volume level only. Holding the mix button in for a further 2-3 seconds takes the unit back to normal
operation and the buttons stop flashing.
Mic Mute
Mutes the microphone input when selected.
When the device is in audio breakaway mode, the input that is highlighted is the last button pressed, it
does not necessarily reflect the full extents of the switcheroo current status. For example if in AV mode
that PC1 was selected then the mode was change to video mode and Video 1 was selected then video 1
would be displayed but the audio would still be set the PC1 and not be reflected on the display at all.