Filter
Top Products
18
Insert your drive as shown.
2. With one hand supporting the drive, fasten the drive with the screws provided.
3. Find a small 4-pin white connector on the power supply and connect it to the male 4-pin connector
on the floppy drive.
2.7 U
SING
F
LEET
-S
WAP
™
The DF-35 includes one set of Fleet-Swap
TM
3.5” drive bays. Each set contain two connectors, for a total of
two hot-swappable SATA drive bays, pre-installed on the bottom of the internal 3.5” drive cage.
A.
P
REPARING YOUR
F
LEET
-S
WAP
™
SATA
BAYS FOR USE
1. Remove the left side panel of the case. Open the Fleet-Release
TM
Access Door by pressing the left
side to release it, then swing it open. Locate the Fleet-Swap bays inside the drive cage.
Fleet-Swap™ default locations