Filter
Top Products
49UPS Network Management Card 2 User’s Guide
Output Relay Page
This option is only available for devices with installed Dry Contact I/O Accessories. Select the
Environment tab, then Universal I/O from the top menu bar. Click Output Relay to display the status of
the output relay and configure its values.
About Page
Click About on the left navigation menu of the top menu bar option Environment to display what
environmental monitoring devices are in use with this UPS and their firmware versions.
Parameter Description
Name A name for this output relay. Maximum: 20 characters.
Location The location of this output relay. Maximum: 20 characters.
Alarm Status Normal if this output relay is not reporting an alarm, or the severity of the alarm if this
output relay is reporting an alarm.
State The current state of this output relay: Closed or Open.
Normal State The normal (non-alarm) state of this output relay: Closed or Open.
Control To change the current state of this output relay, check-mark the setting.
Delay The number of seconds a selected alarm condition must exist before the output relay is
activated. Use this setting to avoid activating an alarm for brief transient conditions.
NOTE: Even if additional mapped alarms occur after the delay begins, the delay does not
restart but continues until the output relay is activated.
Hold The minimum number of seconds the output relay remains activated after the alarm occurs.
Even if the activating alarm condition is corrected, the output relay remains activated until
this time period expires.