Filter
Top Products
UPS Network Management Card 2 User’s Guide6
LED Descriptions
Status LED
This LED indicates the status of the Management Card.
Reset button Resets the Management Card while power remains on.
Serial configuration port Connects the Management Card to a local computer to configure
initial network settings or access the command line interface.
Link-RX/TX (10/100) LED See “Link-RX/TX (10/100) LED” on page 7.
Status LED See “Status LED” on page 6.
Condition Description
Off One of the following situations exists:
• The Management Card is not receiving input power.
• The Management Card is not operating properly. It may need to be repaired or
replaced. Contact APC Customer Support. See “APC Worldwide Customer
Support” on page 108.
Solid green The Management Card has valid TCP/IP settings.
Solid orange A hardware failure has been detected in the Management Card. Contact APC
Customer Support. See “APC Worldwide Customer Support” on page 108.
Flashing green The Management Card does not have valid TCP/IP settings.
1
Flashing orange The Management Card is making BOOTP requests.
1
Alternately flashing
green and orange
If the LED is flashing slowly, the Management Card is making DHCP
2
requests.
1
If the LED is flashing rapidly, the Management Card is starting up.
1. If you do not use a BOOTP or DHCP server, see the Network Management Card Installation Manual provided
in printed format and on the APC Network Management Card Utility CD in PDF to configure the TCP/IP settings
of the Management Card.
2. To use a DHCP server, see “TCP/IP and Communication Settings” on page 60.
Item Description