Filter
Top Products
75UPS Network Management Card 2 User’s Guide
SNMPv1 option.
SNMPv3 option.
Select the identifier of the user profile for this trap receiver. (To view the settings of
the user profiles identified by the user names selectable here, choose Network on the top menu bar and
user profiles under SNMPv3 on the left navigation menu.)
See “SNMPv3” on page 68 for information on creating user profiles and selecting
authentication and encryption methods.
SNMP Trap Test
Path: Administration > Notification > SNMP Traps > test
Last Test Result. The result of the most recent SNMP trap test. A successful SNMP trap test verifies
only that a trap was sent; it does not verify that the trap was received by the selected trap receiver. A trap
test succeeds if all of the following are true:
• The SNMP version (SNMPv1 or SNMPv3) configured for the selected trap receiver is enabled on
this device.
• The trap receiver is enabled.
• If a host name is selected for the To address, that host name can be mapped to a valid IP address.
To. Select the IP address or host name to which a test SNMP trap will be sent. If no trap receiver is
configured, a link to the Trap Receiver configuration page is displayed.
Remote Monitoring Service
Path: Administration > Notification > Remote Monitoring
The APC Remote Monitoring Service (RMS) is an optional service that monitors your system from a
remote operation center 24 hours a day, 7 days a week, and notifies you of device and system events.
To purchase the APC RMS service, contact your APC vendor or click on the link on the top
part of this screen page: APC RMS Web site.
Item Definition
Trap Generation Enable (the default) or disable trap generation for this trap receiver.
NMS IP/Host Name The IPv4/ IPv6 address or host name of this trap receiver. The default, 0.0.0.0, leaves
the trap receiver undefined.
Language Chose a language from the drop-down list. This can differ from the UI and from
other trap receivers.
Item Definition
Community Name The name (public by default) used as an identifier when SNMPv1 traps are sent to
this trap receiver.
Authenticate Traps When this option is enabled (the default), the NMS identified by the NMS IP/Host
Name setting will receive authentication traps (traps generated by invalid attempts to
log on to this device). To disable this ability, unmark the check box.