Filter
Top Products
15
6. Press Ctrl-W when done to save these changes.
7. After making IP changes, the system needs to be reset. Press the Esc key to return to the System
Manager Menu.
8. Go to System Manager/Reset. Use the arrow keys to select Yes to proceed with Reset.
2.6 SNMP Host Access
When the reset is complete the box should be seen on the network. If not, check the IP information again
with your network administrator to ensure that all the data is correct. By default, any PC on the network can
manage the switch via the Web Interface. However, if this is not desired, you may enable Host
Authorization, allowing only hosts that are listed in the SNMP Host Table to access the box.
Follow these steps to configure Host Access:
1. Choose a. System Manager from the Main Menu.
2. Next choose h. SNMP Management.
3. Select Host Table by using the arrow keys and pressing Enter.
4. Enter the host name and IP address. Repeat this for as many hosts as necessary. Enter Web
Interface for the community string. Press the spacebar when Disabled is highlighted. The status will
change to Active.
5. When done entering hosts, press Ctrl+W to save this data.
For other management tasks, please refer to Chapters 3 and 4. To review switching concepts, please refer
to Chapter 6.