Filter
Top Products
18
3.3.2 IP Settings
There are three tunable parameters to be set by the system administrator:
• Enter site-specific IP address, Gateway address and Network mask
• Click Apply to change the IP settings
• Save Configuration to NVRAM and reset the system to implement the changes
3.3.3 NVRAM Admin
After making any changes to the screens within the Web Interface, users must save the changed settings to
Non-Volatile Random Access Memory (NVRAM). This is done in the system administration screen in order
for the new settings to remain after a system reboot.
Save Configuration to NVRAM
• Click on the Save button to save configuration to NVRAM
Restore Defaults
• Click on Restore Defaults to reset the switch’s parameters to their original default settings. In
order for changes to occur, you must reset the switch.
Note: Network IP settings (i.e. IP address, Gateway Address, Network Mask) will not be affected by
this command.
Restore Defaults without Boot Parameters
• Click on Restore Defaults without Boot Parameters to reset MOST of the switch’s parameters,
but leaves the IP address information and the boot loader configuration alone, so that the switch is
still up and manageable.