Filter
Top Products
Installation
Page 2-6
3 Place the device into the 19-inch rack and attach it firmly.
Ensure that the ventilation holes do not get blocked.
Figure 2-6 Rack mounting
Connecting Network Devices
The Auto-sensing capability of the NetStacker II hub allows you to connect
10Mbps and/or 100Mbps devices.
Connecting Workstations or Servers
To connect your hub to workstations, servers, or other nodes:
1 Be sure each computer has either a 10Base-T or 100Base-
TX Ethernet Network Interface Card (NIC) installed
2 Connect one end of the UTP cable to the RJ-45 port of the
Ethernet card in each computer as shown in Figure 2-7.
❑ for 10Base-T use UTP Category 3 cable or better
❑ for 100Base-TX use UTP Category 5 cable or better
3 Plug the other end of the cable into one of the RJ-45 ports
on the hub, as shown in Figure 2-7.
13 14 15 16 17 18 19 20 21 22 23 24
123456789101112
MII
Module
Slot
NS2024
Uplink
Normal
Uplink
100M
10M
COL
Power
NetStacker II
Hub ID Number
1
23
4
5
6
7
8
9
1011
12
1
23
4
5
6
7
8
13
1415
16
17
18
19
20
21
2223
24
100Mbps
10Mbps
100Mbps
10Mbps
Stackable Dual-Speed Hub
SHBBook Page 6 Wednesday, March 3, 1999 8:03 PM