Filter
Top Products
AP100 Hardware Reference Guide 19
II. System Components
II. Components
3.5” Device Cage
Device Cage (3.5”) Floppy Mounting
The 3.5” device cage has a slot and three screw holes on each side for a 3.5”
floppy device on the top most space. The floppy must be aligned so that the
first hole matches.
1.44MB floppy disk drive mounted in the 3.5” device cage
Align this hole
Device Cage (3.5”)
The 3.5” device cage is used for mounting one 3.5” floppy device (such as
a 1.44MB floppy, LS-120, MO, or ZIP disk drive) and two hard disk drives.
Before devices can be installed or removed from the 3.5” device cage, you
must remove the device cage from the chassis.
3.5” Device Cage Removal Procedure:
1. Remove the stabilizing link bar, if not already removed.
2. Rotate the locking lever clockwise using a screwdriver inserted from
the top of the lever. (It is very difficult to turn it with your fingers, it
requires that you pull the lever outward first before turning it.)
3. Slide backward to remove the 3.5” device cage.
4. Mount the 3.5” device cage using the reverse procedure. (Locking the
lever is possible with your fingers.)
Unlocking the 3.5” device cage
Locking lever