Filter
Top Products
ROG Striker II Formula
2-33
3. Serial ATA connectors (7-pin SATA1–6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
®
MediaShield™
RAID controller.
•
These connectors are set to [Disabled] by default. In Standard IDE mode,
you can connect Serial ATA boot/data hard disk drives to these connectors.
If you intend to create a Serial ATA RAID set using these connectors,
enable the [RAID Enabled] item in the BIOS. See section 4.5.3 Onboard
Devices Conguration for details.
•
For RAID 5, use at least three hard disk drives. For RAID 0+1, use at least
four hard disk drives. Use two to four Serial ATA hard disk drives for each
RAID 0 or RAID 1 set.
• Before creating a RAID set, refer to 5.4.2 NVIDIA
®
RAID congurations or
the manual bundled in the motherboard support DVD.
STRIKER II FORMULA
®
STRIKER II FORMULA IDE connector
NOTE: Orient the red markings
cable to PIN 1.
PRI_IDE
STRIKER II FORMULA
®
STRIKER II FORMULA SATA connectors
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA3
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA4
GND
RSATA_TXP5
RSATA_TXN5
GND
RSATA_RXP5
RSATA_RXN5
GND
SATA5
GND
RSATA_TXP6
RSATA_TXN6
GND
RSATA_RXP6
RSATA_RXN6
GND
SATA6
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA1
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA2