Filter
Top Products
2-30 Chapter 2: Hardware information
10. ATX power connectors (24-pin EATXPW, 4-pin ATX12V)
These connectors are for ATX power supply plugs. The power supply
plugs are designed to t these connectors in only one orientation.
Find the proper orientation and push down rmly until the connectors
completely t.
• Use of an ATX 12 V Specication 2.0‑compliant power supply unit
(PSU) that provides a minimum power of 350 W is recommended for
a fully‑congured system.
• DO NOT forget to connect the 4-pin ATX +12 V power plug;
otherwise, the system will not boot up.
• Use of a PSU with a higher power output is recommended when
conguring a system with more power consuming devices. The
system may become unstable or may not boot up if the power is
inadequate.
EATXPWR
ATX12V
P5LD2 SE ATX Power Connectors
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
+12 Volts
-5 Volts
+5 Volts
+3 Volts
-12 Volts
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12 Volts
+3 Volts
+5 Volts
Ground
+12V DC
GND
GND
+12V DC
R
P5LD2 SE
Below:Mic In
Center:Line Out
Top:Line In