Filter
Top Products
1-301-30
1-301-30
1-30
Chapter 1: Product introductionChapter 1: Product introduction
Chapter 1: Product introductionChapter 1: Product introduction
Chapter 1: Product introduction
3.3.
3.3.
3.
Serial ATA connectors (7-pin SATA1, SATA2)Serial ATA connectors (7-pin SATA1, SATA2)
Serial ATA connectors (7-pin SATA1, SATA2)Serial ATA connectors (7-pin SATA1, SATA2)
Serial ATA connectors (7-pin SATA1, SATA2)
These connectors are for the Serial ATA signal cables for Serial ATA
1.5 Gb/s hard disk drives.
If you installed Serial ATA hard disk drives, you can can create a RAID
0, RAID 1, and JBOD configuration through the onboard VIA VT8237A
RAID controller.
Important notes on Serial ATAImportant notes on Serial ATA
Important notes on Serial ATAImportant notes on Serial ATA
Important notes on Serial ATA
•
The Serial ATA RAID feature (RAID 0, RAID 1, and JBOD) is available
only if you are using Windows
®
2000/2003 Server/XP operation
system.
• Install the Windows
®
2000 Service Pack 4, the Windows
®
XP Service
Pack1 or later version before using Serial ATA.
• Please refer to section “
Onboard Devices ConfigurationOnboard Devices Configuration
Onboard Devices ConfigurationOnboard Devices Configuration
Onboard Devices Configuration” in
the BIOS for details on SATA RAID configuration.
®
SATA connectors
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA1
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA2
4.4.
4.4.
4.
Jmicron Serial ATA RAID connector (7-pin SATA_A)Jmicron Serial ATA RAID connector (7-pin SATA_A)
Jmicron Serial ATA RAID connector (7-pin SATA_A)Jmicron Serial ATA RAID connector (7-pin SATA_A)
Jmicron Serial ATA RAID connector (7-pin SATA_A)
This connector is for a Serial ATA signal cable for a Serial ATA hard
disk drive that you can combine with an external Serial ATA 3 Gb/s
device to configure a RAID 0, RAID 1, and JBOD set through the
onboard Jmicron SATA RAID controller.
Do not remove/unplug external SATA devices when running under RAID
mode.
®
SATA RAID connector
SATA_A
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND