![](http://pdfasset.owneriq.net/b/b6/bb60b35f-cf74-43cb-8e45-ce410f450a9a/bb60b35f-cf74-43cb-8e45-ce410f450a9a-bg2a.png)
2-20
Chapter 2: Hardware information
Chapter 2
2.2.7 Jumper
1. Chassis Fan control setting (3-pin CHAFAN_SEL)
These jumpers allow you to switch for fan pin selection. The CHAFAN_SEL jumper is for
the front fans and rear fans control. Set to pins 1–2 when using 3-pin fans or pins 2–3
when using 4-pin fans.
• If you use a 4-pin fan but set the jumper to pin 1-2, the fan you installed may not work.
• If you use a 3-pin fan but set the jumper for a 4-pin fan, the fan control will not work and
the fan you installed will always run at full speed.