Filter
Top Products
CE680 / CE690 User Manual
18
Firmware Upgrade
Refer to The Firmware Upgrade Utility in Chapter 5 for a step-by-step guide
on upgrading the firmware. In summary, do the following steps:
1. Push and hold the Operation Mode pushbutton and power on the Local or
Remote unit to enter the firmware upgrade mode.
2. Connect a computer to the RS-232 port of the local/remote unit.
3. Use ATEN Firmware upgrade utility to do the firmware upgrade.
Note: Do these steps for the Local and Remote units individually (Single Unit
Mode, page 26). To upgrade the units together, see Local and Remote
Mode, page 29.
Wake Up PC
When at the remote console’s location and you want to wake a computer on the
local site, use the Wakeup PC pushbutton on the front panel of the CE680R /
CE690R.
Make sure to use an RS-232 cable to connect the local computer to the CE680L
/ CE690L in order for this command to work.
Note: The PC’s BIOS should support RS-232 wake up function.
CE680R / CE690R