Filter
Top Products
SENDING A FAX
1.
Make sure the power is ON. If IN USE LED is on, the power is ON. If not
turn
ON the POWER
SWITCH.
2. Place the document FACE DOWN and slide it into the loading slot. The unit will grip the paper.
NOTE:
The Document Feeder can accept only one page at a time
3. Set the Slide Switch to FINE to increase resolution at the receiving unit, or set the Slide Switch
to “Photo” to transmit a photo or halftone original with various shades of gray.
Slide Switch
Note:
When communication begins, IN USE LED blinks. If a communication error occurs, the
unit will sound a warning tone.
4. Pick up the handset and dial the receiving unit you want to call. Dial manually or use Auto-Dial.
(See page 16.)
5. When you hear
a tone, press
the START key and hang up the telephone handset.
If
a person answers the phone, tell her/him
to press the START key on the receiving unit. When you
hear a tone, press the START key and hang
up your phone.
Your machine will begin to transmit the original loaded in the document feeder.
6. After one page is transmitted, a four-second beep sounds and the unit holds the telephone line
open. You can insert another page to transmit to the receiving unit, during this 4 second period.
7. After sending, your unit will disconnect and return to the Standby mode.
CAUTION
If the machine starts to send the original and for some reason stops without sending all of it, DO
NOT pull it out of the loading slot. Open the control panel cover: (See page 31.) This will release the
gripping pressure and you can then remove the original without damaglng’your
machine.
13